PDI barrel and different brand barrel ends

1688 Views 3 Replies 2 Participants Last post by embed, Oct 6, 2008

woz

Discussion Starter · Sep 24, 2008

I see silencer adapters, flash hiders, and barrel ends all over the place but no one seems to carry the PDI brand. I currently have a PDI fluted barrel installed on my Maruzen Type 96 and I was wondering if anyone has had any successful first hand experience with other brands of ends for the PDI fluted barrel.
The reason why I'm even bringing this up is because the original barrel end will not fit on the PDI outer barrel but the PDI barrel end will fit on the end of the original outer barrel :

I currently own a PDI barrel plug but would love to have this on the end since my inner barrel sticks out just a little. http://www.redwolfairsoft.com/redwolf/airsoft/ProductDetail?prodID=14042

Save

1 - 2 of 4 Posts

embed

· #2 · Sep 25, 2008

It will most likely fit because PDI makes the muzzle brake you're considering. I've looked around at a couple less known retailers and I still can't seem to find one yet.

Anyway, if you'll settle with just an end cap or suppressor adapter take a look, you can buy PDI products straight from PDI:

http://www.x-fire.org/etop/t96.html

Save

embed

· #4 · Oct 6, 2008

This is taken right from PDI's description of your barrel, assuming you have the full length and not the short one:

"This have no muzzle cap.Please use normal one,or PDI muzzle cap."
http://www.x-fire.org/type96/e.t96_durabarrel_fl.html

As for any doubts you have with ordering straight from X-fire, I've never had any problems with them.

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month