Airsoft Sniper Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,199 Posts
Discussion Starter · #1 ·
I know I'm going to sound like a twat saying this but:

Be careful not to over tighten those screws a the side of the chamber which keep it in place, why? Well, I found out the hard way, I over tightened them without realizing :doh: and put a dent on the inside of the barrel so now BB's go everywhere and have mad fps deviations. I ruined a €40 barrel! :ashamed:

Just be careful! At least now I know why my chamber was acting up :yup:
 

·
Administrator
Joined
·
6,201 Posts
Actually I've done that with my stock M24 chamber but I installed some custom screws to hold the barrel!
I ruined the stock barrel now I'm using the barrel from the Geneth WA2K and that's a 10 y.o. barrel!!!!


Wolf
 

·
Registered
Joined
·
2,199 Posts
Discussion Starter · #3 ·
Actually I've done that with my stock M24 chamber but I installed some custom screws to hold the barrel!
I ruined the stock barrel now I'm using the barrel from the Geneth WA2K and that's a 10 y.o. barrel!!!!

Wolf
Note for everyone then, be careful when tightening screws!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top