Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
191 Posts
I had sort of the same issue, and then I realized the adjustment screws were blocking the cylinder head from entering the chamber. One fubar'd screw and a grooved cylinder head later, I have a working gun. And try adjusting the little plastic ring INSIDE the receiver, make sure the more rounded side is facing out, and the totally flat side is facing inside. I had the same issue with the barrel, just took some patience, fidgeting, and a lot of silicone spray to finally work.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top