Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
Its official, I am an idiot when it comes to putting together my gun. As I was screwing the outer barrel onto the body of the gun, I damaged the PDI hopup adjustment screw by crimping the top with the cylinder head. Now I know that PDI sells a repair kit, but right now Airsoft atlanta is out of stock, Evike doesnt carry them, and its not on amazon either. However Amazon DOES have the repair kit for the VSR-10 hopup. Does PDI use the same set screws in both of these hopup systems?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top