Airsoft Sniper Forum banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
3,434 Posts
Well the PDI fluted barrel (for l96) is meant for the Maruzen rifle, so it should fit...


Now the clones however, are a different story, such as the UTG mk96. But woogie was able to modify it to fit somehow.
 

·
Premium Member
Joined
·
3,434 Posts
woogie said:
They will fit on a clone, just need to do a little work to the threads.
What kind of work would have to be done to the threads? Could you give me a few details (might look into one of these some day)? Or direct me to your thread that you had (I believe you had one on modifying the barrel to fit, am I right?).
 

·
Registered
Joined
·
3,788 Posts
I just had to sand the threads on the barrel a little bit. The threads that are on the fluted barrel are really sharp, and the threads in the MK96 reciever, are fairly rounded. So just a little time with some sand paper and you are good to go
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top