[toomanybbs]

PDI Trigger removal?

So my bar-10 came in; very happy with it. It has a PDI trigger, which looks fantastic by the way, but I want to remove the pin that goes into the cylinder and comes into contact with the spring guide.

I've had a bar-10 before, but not with a PDI trigger, I just want to make sure I don't screw anything up so...answer away!

 

[MGunner]

There are two set screws that hold the spring guide stopper in place, remove those and you will be able to pull the stopper out.

Be careful putting them back in, if you make them too tight the mech wont work.

 

[Lightbulb]

I assume to remove the cylinder? I always just take the front barrel off and leave it in the gun. That way you don't need to hammer the spring guide stopper back in...

 

[toomanybbs]

Thanks guys, I got it; it was just really stiff.