Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
297 Posts
Discussion Starter · #1 ·
Today I got a utg tune up kit for my Javelin/Snow Wolf m24. I put the new spring, steel spring guide, and steel piston in my cylinder. After firing one shot I noticed my bolt was not catching when i pulled it back. I was using stock sears but could they honestly strip after one shot? Could it be something else wrong here?
 

·
Registered
Joined
·
297 Posts
Discussion Starter · #4 ·
I took it apart and the and the sears look fine and the trigger box isn't cracked. I think I'll look into getting some new sears anyway. Any recommendations?
 

·
Registered
Joined
·
297 Posts
Discussion Starter · #7 ·
I started messing with the gun for a little bit and noticed that when I put it on safe it would lock and I had to push it forward with lots more effort. Also I noticed the piston seemed to be slowly grinding its way down the cylinder. Im going to lube the crap out of it and see if that helps.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top