Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
297 Posts
Discussion Starter · #1 ·
Earlier when working on my gun I noticed that the piston sear wouldn't catch. I thought i had a stripped sear until I tried to cock it back when it was on safe. It seemed to work but the bolt wouldn't go all the way in. Is there any way to fix this?
 

·
Registered
Joined
·
297 Posts
Discussion Starter · #3 ·
Actually I have a javelin m24 which has a trigger box that I believe is similar, if not identical to those "UTG MASTER SNIPERS". Also the trigger box was working fine, and all of my springs where in, and the piston sear was returning to the right place. I think it may have been a problem with the cylinder, because the end of it was severed right out of the gun when I tried to rack back the bolt the other day. I have a new one on the way, hope it works.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top