Airsoft Sniper Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I have a few questions regarding KA Sig 556 DMR. Here it goes:
1. How is the build quality of this gun?
2. Does it use standard version 3 gearbox?
3. If it use a standard version 3 gearbox, is the air volume enough for 550mm barrel when using 0.36g bb at 400fps with 0.20g?
4. Is the hop up unit standard M4 hop up unit, since I want to use HS5's LTH.
5. Is the any weak point in the gun that I need to be careful of?
 

·
Registered
Joined
·
32 Posts
Seeing as this gun is essentially the same as a normal King Arms 556, then yes it does have a standard v3 with a long air nozzle, and uses a m4 hopup unit. As for the cylinder, you may need a bore-up since a cylinder with no holes goes up to around 509 mm barrel.
As for build quality, King Arms tends to have relatively good products so I would assume it would be pretty good.
I used this video as a reference :

Hope this helped!
 

·
Registered
Joined
·
744 Posts
Thanks for posting this by the way. I'm going to get get the shorty version. Finally solved my v3 gearbox with mag compatibility problem. I don't care for the v2 at all, but now I can run a v3 with m4 mags. Even though it won't be a DMR, its still a damn sturdy box.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top