Airsoft Sniper Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter · #1 ·
The gun tech who was working on my TM M14 tried putting a R-hop into it but was having problems. He said that he had to get the R-hop so thin that after a few round though it the R-hop "lost it's shape" and caused a jam. Has anyone else heard of this happening or did just make a mistake in the install? He has put an R-hop in successfully into his M4 so I doubt it's his skill but you never know.
 

·
Registered
Joined
·
909 Posts
It really does seem like there's a lot of room for error with installing these R-Hops unless you're an expert on it. When I decide to put on in my gun, I'll probably set aside a weekend to work through or just pay somebody to do it.
 

·
Registered
Joined
·
100 Posts
Discussion Starter · #5 ·
Thank you I figured he must have made a mistake even though he did it before. A M4 hop up is just a bit different then a M14 one.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top