Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey Guys:)

My english is not so good but i hope you guys understand me.

I have a question about building a R Hop into a standart VSR 10 Barrel
with the ´open cut´.
Can you tell me if its possible to do that with this type of barrel?

best regards from Germany ;)
 

·
Registered
Joined
·
134 Posts
Never heard of it not being possible, but since it's already non-bridged, you could go for a maple leaf bucking and concave nub. A lot easier
 

·
Registered
Joined
·
4,148 Posts
It's possible, yes. Just like any other R-hop except there's no bridge and you let the patch run all the way to the edge of the hopup window.

If you have no experience with R-hops however, a maple leaf bucking may be an easier option yielding almost identical performance :hehe:
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
Hey Thank you very much for the reply!
I have R Hops in my aeg since a long time ago so that should be no Problem:)

My question is answerd now, Thank you! :)
 
1 - 4 of 4 Posts
Top