[metallicafatcat]

Just FYI, you'll need a mill to get this mod to work. Or a very powerful dremel and a sturdy hand.

 

[metallicafatcat]

I'm not sure if it's even possible to the M14? I thought that they used different cuts?

 

[metallicafatcat]

The ER is a much more powerful version of the R-Hop. It will, from what I've heard, easily over hop anything under .4s. The G&G M14 uses the same hop up as the AUG.

 

[metallicafatcat]

That's his next project...

 

[metallicafatcat]

Sounds like you had the reverse magnus effect due to the LRB and the patch.

 

[metallicafatcat]

I wouldn't be suprised if he was using some allen set screws to bend the barrel.

 

[metallicafatcat]

To be honest, I don't really know. He has a way of doing things that others claim impossible. He could be using a different rifle than one of his numerous M4s, but I wouldn't be sure which. I'll try and prod some information out of him, but I doubt he'll give me too many details.

 

[metallicafatcat]

I think I will try HS5's R-Hop down the road. What can it hurt it is only $12 for 3 patches.

Plus three buckings and barrels assuming you screw all but one of them up...which I seriously hope you don't do.

 

[metallicafatcat]

Guys, just as a heads up, if any of you are interested, appearently HS5 is doing a limited run of Prommy barrels cut and installed with the ER hop. It's supposedly using a 455mm barrel, which is the most accurate on several individual accounts.

 

[metallicafatcat]

My guess is as good as any body others. I'd say Bob has the right idea with it being some sort of tubing. I mean you could go all out and buy some and have them analyzed in a lab, but that would bring up some moral questions about stealing someones' idea. All I can say is that whatever he is using, there is probably some sort of winter variant to it, due to there being an IR hop.