Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
Working on my APS2 and trying to attach the rear magwell block but part is stripped seems to be common problem as I have 2 of these and both have same issue..
What are my options? I was thinking of JB weld in place?
Brad
 

·
Registered
Joined
·
2 Posts
Which bit is stripped? The stainless block, or where it threads into the body? I haven't had that strip (yet) but everything else I just re-drilled and tapped the holes a size bigger. That would be my suggestion.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top