Airsoft Sniper Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter · #1 ·
i have been playing the sniper role the last few gamedays and i am really enjoying it. the one to be desired with my TM VSR is reducing the number of flyers. does anybody have any ideas how this can be achieved? i am getting very good range and accuracy but i would like it to be more consistent. dont get me wrong i am getting some great kills 200-300ft. but of course the ideal view of the bb through the scope would be for the it to climb up to the crosshair and hang there untill it hits its harget.

right now every so often it flies right or left to the 1-4 mildot in my scope.

here is my setup,
TM VSR
PDI teflon cylinder,
PDI lightweight piston.
TM stock trigger box with PDI sears
TM precision hop chamber
PDI 6.01 430mm inner barrel
PDI w hold bucking
x4 PDI barrel spacers
PDI nossel
500FPS spring (.20)

soon to install, dangerwerx hop up arm.

for ammo i am using washed .40 bb bastards.
 

·
Registered
Joined
·
97 Posts
You mean your BB spins to the sides? If so try to check of TDC mod. helped me abit.
 

·
Registered
Joined
·
2,893 Posts
First thi to try wd be to shim your hopup arm. If that is only helping a bit then try the TDC mod which will keep the arm straight and center every time. nd I know this sounds obvious, but make sure you clean everything (bucking, barrel, etc.).If any dirt gets in the barrel or the bucking, it will screw with your accuracy.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top