[goldentrigun]

If anyone has installed one of these and can help me I'd greatly appreciate it.

The trigger,cut-off lever, and selector plate strike the mosfet perfectly and I modified the selector plate so that it cannot physically come into contact with the mosfet. The only thing I physically had to change was the wiring from the rear to the front.

My problem:
When I plug in the battery I can go through the setup process normally without any issue. However once I pull the trigger on semi it will shoot full auto (10-15 shots) then stop. The same thing happens when the selector is on full auto.
I have also tried cycling through the different options (such as semi only with precocking) and to my dismay the same problem.

I'm not so sure what happened as when I test fired (gearbox and pistol grip only) without the piston I was getting proper cycles and was not having the same issue I described above.

Any ideas on what is wrong?

I can post the setup but I'm fairly certain that it isn't a compatibility issue. Maybe something which I have overlooked? I'm not sure. I'll try to get a video in here shortly.

 

[nrlegg]

it is actually indeed an incompatibility issue in regards to the selector plate and how it interacts with the micro switch. Its not putting enough pressure on the micro switch and thus your long burst of shots.

As a test, take off the plate and press down on the micro switch and pull the trigger. The gun should fire correctly. It happened to me with Lonex GB and the Lonex Selector Plate. I used a KWA plate and that fixed the issue but I imagine its a case to case issue depending on the Gearbox.

Best of luck to you

 

[goldentrigun]

It shoots full auto no matter what shooting mode it is in.

I can see the selector plate pushing down on the micro switch.

 

[nrlegg]

But did you do the test I offered?

Yes it was pushing down the switch on mine too, but it wasnt enough.

 

[goldentrigun]

I have not yet. I'm currently in the process of getting a video up.
I just don't understand why it all of a sudden wanted to stop working. Nothing has changed on or inside that gb and it tested fine before it went into the gun.

EDIT: Everything works without the spring,piston,cylinder combo.

I went to perform the test above and noticed before I even did performed the test it was shooting using the adaptive rof. Then went to program to semi only and it worked aswell.

EDIT2: upon further fiddling I noticed that periodically I would end up with the same problem I described earlier.
This leads me to believe that it's the cut-off lever (maybe).