Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
291 Posts
The SAR 10 uses a gas bolt meaning HPA is impossible to do effectively, which also means your consistency can never be good.
Swap out the gas bolt and trigger assembly for a VSR 10 spring powered system (verified to be compatible).

Install barrel spacers, do the TDC mod and install an R hop.

If you still want to use gas, just buy a new rifle with gas mags (KJW M700 hooked to HPA)...most cost effective route. The SAR 10's magazine isn't even in the right place so it's unrealistic anyways.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top