[l96ninja]

Does anyone know the exact size for the two screws that hold the L96 trigger box into the receiver? My TSD metal trigger box didn't come with any. Thanks!

 

[fuzzywolly]

Another member on another forum had the same problem. Take the box into your local hardware store. The guy said they helped get him the screws he needed very quickly.

 

[l96ninja]

Thanks Fuzzy, I'll try that. I was worried they would be some kind of rare diameter/length that would be hard to find.

 

[fuzzywolly]

I thought that too, but they're bigger in size, unlike the PDI hex screws which were impossible to find. From what I heard/just looking at the screws, you should be fine. Might even be able to switch to flat heads instead.

 

[l96ninja]

To anybody who runs into this problem, the screw that holds the piston head onto the piston in the stock setup is a PERFECT fit.

 

[fuzzywolly]

To anybody who runs into this problem, the screw that holds the piston head onto the piston in the stock setup is a PERFECT fit.

Don't you need two screws though?

 

[l96ninja]

To anybody who runs into this problem, the screw that holds the piston head onto the piston in the stock setup is a PERFECT fit.

Don't you need two screws though?

Yep, I had two stock pistons