[Han5gruber]

I've just purchased the SDiK kit for a well mb01 and but unfortunately its not giving me the performance I wanted. I'm currently only getting around 2.5Jon .4g bb's with 2.2J on .2's. I've opened the SDiK to see if there's any reducer kit already installed and there appears to be a while plastic tube already in there, I can't seem to remove this and didn't want to force it out?

Has anyone else had any experience with the SDiK? I hoped to get around 3-3.5J with .48's but at this rate I can only use 4-.43g due to the low fps I'm getting. This image shows the white plastic cylinder I believe to be the volume reducer?

Thanks

 

[Steveocee]

Absolutely wait for someone else more knowledgeable to chime in but I thought this bit had to be removed with a knife, kind of craft knife and do a circle and it will come away?

^^^I haven't had my hands on a mancraft kit but I'm sure I read that somewhere.

 

[whalesmash]

Yes, that is a volume reducer. It makes the system a little more efficient since the SDIK almost always overvolumes every gun it goes into. What pressure are you running? You should be able to reach your desired power level even with the reducer installed.

 

[Snappuh]

You should be able to achieve your desires easily with the SDiK. Can you give us some insight about the rest of your setup? Barrel, bucking, regulator, etc. Unless your SDiK unit is actually defective, I can’t imagine how it would be so difficult to get 3+ joules on heavy ammo. My SDiK was over volumed for .40 with the white tube fully intact and a stock BAR-10 brass barrel.

You can force the white tube out by tapping it with something that can reach inside. Be carful to NOT bend the thin walls of the cylinder body. Even slight damage could render the threads useless.