Shaving down the nub?

1775 Views 6 Replies 4 Participants Last post by MiloXC3, Jun 12, 2012

MiloXC3

Discussion Starter · Jun 11, 2012 (Edited)

Hi guys,

I've recently purchased a new internally stock VSR-10.
I'm planning on doing all the DIY mods I can to squeeze out as much as I can from it and one mod I was considering was shaving down the bucking moud.
I was wondering if shaving it down would affect the performance of the hop up? I've heard somewhere that it helps!

Thanks, Milo.

Save

1 - 1 of 7 Posts

fdkrew

· #6 · Jun 12, 2012

Doing a TDC mod will help apply as much hop you need to correct that issue. Also no right hooking too.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.