Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
56 Posts
I've performed customer work on just about every VSR clone rifle available to date; & although I've never seen this issue on the TM VSR or JG BAR-10 variant, I have ran into it on several of the other brands of VSR clone rifles.
The remedy is to round the corner edge of the safety lever where it contacts the trigger safety stop block.
Trimming & polishing the safety mechanisms contact surfaces is also a common modification that must be performed on the stock trigger assembly when customizing a trigger by eliminating unnecessary trigger creep & therefore reducing the overall length of the trigger pull for a custom rifle feel for its operator.
Snipers desire the least amount of trigger pull that is possible on a weapon platform, hence the common shooter's phrase "touching it off"!

The BushMan
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top