Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
56 Posts
If it´s a Airsoftpro spring it´s overpowered. Even the new shorter ones. The piston doesn´t look that good either with no delrin/plastic/teflon guiders on the front and rear.
The 45 trigger pushes the bolt up in the rear and subsequentially lower in the front. Guaranteed scratches in the cylinder if it doesnt have smooth guides.
The Airsoftpro cylinders are a tad smaller so check compatibility. I would use the same manufacturers piston and cylinder.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top