Airsoft Sniper Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,893 Posts
Discussion Starter · #1 ·
I got my Bar10 and it is working fine so far. Almost all of the parts i ordered for it came already except for the Action Army z-trig. It will be here in a few days but for now is it safe to use the m170 spring with my stick trigger with stock sears in the meantime?

I searched for this here and on google but couldn't find any good info on it. Thanks.
 

·
Registered
Joined
·
296 Posts
Just wait a few days, much safer. Oh and if the AA zero trigger doesn't fit then it may be because the trigger stopper is too wide. This was a problem I had when fitting to my Bar 10.
 

·
Registered
Joined
·
2,893 Posts
Discussion Starter · #5 ·
By trigger stopper do you mean the pin you can pull out that holds back the spring guide when you cock it? If so, I can just grind it down.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top