Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
76 Posts
The tube is manufactured by welding/gluing two sections. The one closer to the pistol is 100mm long - so you could try seperating the two segments. Fill it with washers made of Scotchbrite and add a closed cell foam washer each 4 Scotchbrite washers. Inner diameter has to be at least 8mm, but 10mm is safer and works nearly as good as 8mm. With this setup the 100mm length is not recognizably louder than the full length but much easier to handle.
 
1 - 1 of 1 Posts
Top