[Klab]

I removed the bottom plate and the retainment pin, but I can't remove the body from the outer housing. I only can move it slightly back and forth and sideways, but not out of the housing. What's wrong?

 

[Klab]

Right, thanks mate!

Now I'm stuck again - I can't remove the back plate. I can move it 2mm at any side, but it's getting pulled back in.

Surprisingly I never had a knock lever - is that normal? The rifle once worked fine and I never have seen this part before..

 

[Klab]

Thank you anyways, I'll try my very best soon.:nuts:

 

[Klab]

Finally I managed to disassemble and reassemble the magazine, thank you very much!

(It still leaks though..)