Airsoft Sniper Forum banner
1 - 16 of 16 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello,

As i have a a&k dragunov svd and i would like to have it more accurate at long range, i would like to put a tightbore barrel in it and an other hop up bucking.

My question is the following : What is better for this spring sniper ?

- Guarder 6.02 , 650mm
- MadBull 6.03 , 650mm

I use flashballs 0.30gr (5,95 +- 0,01mm)
As i would put an other barrel in it and the fps would increase , i'd put an other spring also.
A M130 would be good i guess ?? Just to be at the 450fps again.

Thanks ,

Kenneth.
 

·
Registered
Joined
·
2,199 Posts
wolfgeorge said:
The stock RS barrel is 690mm!! So I put in a shorter one and it was worst.
A couple of friends tried them in their M4's and also said bad things about them.

Wolf
Sorry, I wasn't clear, I meant as in being longer it is easier to take damage, i.e. get bent.
 

·
Administrator
Joined
·
6,268 Posts
The barrel was in the Barrett,I bought the gun brand new and I've skirmished with it 3 times, it's impossible to have damage the inner barrel and not the outer!
I checked it before I install it in the RS and it looked OK.

Wolf
 

·
Registered
Joined
·
55 Posts
Madbulls are of an acceptable quality, atleast from the places I peruse. The general consensus is that you won't notice an appreciable difference between a madbull and a prommy.

At 200ft I am hitting a piece of a4 paper about every time(been having bb issues as of late).

Now the 6.23 magnus. Someone needs to investigate that thing.
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top