Airsoft Sniper Forum banner

thread size

1644 Views 3 Replies 3 Participants Last post by  ~Ranger~
Hello first post here!

I have just piced up a cheap vsr that needs abit of attention, the main problem i have is that the RIS mount threads on the top of the receiver are not catching the bolts tight.

Dose anyone no the size of these and what would be the bore up side if i was to cut a new thread in them?
1 - 2 of 4 Posts
Yes thats was a very helpfull, thanks for reading the question, bye now :lame:
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.