[TurtleSniper]

Hello everyone! I was wondering if I could put any spring in the TM l96. I've heard a little bit of both, but have no clue. Also can I upgrade just the sear or do I have to upgrade the whole trigger unit? One more. What will getting a new cylinder and piston do for me? Thanks for helping!

 

[Mental96]

AirsoftPro.cz is your answer for upgrading the tm L96.

Please upgrade the whole trigger unit if a stronger spring is desired.

 

[indycar]

AirsoftPro.cz is your answer for upgrading the tm L96.

Please upgrade the whole trigger unit if a stronger spring is desired.

What Mental said and use search. TM L96 is same rifle as well l96 so I'm pretty sure we covered upgrades here.

 

[TacticalBeard]

No.... well make two l96, the maruzen clone and the tm clone.

 

[indycar]

No.... well make two l96, the maruzen clone and the tm clone.

Yes but he's asking about TM L96. well L96 aws is same gun as TM L96

 

[Razinger]

I am pretty sure as long as it is near 200mm in length it should be fine. 13mm OD with 11mm ID. I am going to try to get a VSR 10 spring with the same dimensions and see if it will be compatible with my well. If not then you are pretty much stock with a hand made spring or the stock TM l96 AWS 140 spring.

 

[indycar]

Pru?ina M170 pro odst?elovací pu?ky AWS a MB44xx - AirsoftPro.cz

 

[Razinger]

Pretty close to 200mm. I forget what the length of my stock spring is. Should be super insane to pull since it is a spring of AirsoftProCZ especially 170. If you can get a PDI 250% spring it will work. Action army 150-170 spring will work too. First off what FPS are you looking for?


Razinger | The one, The only..