Airsoft Sniper Forum banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
So I recently purchased a TM MK23. I disassembled it for maintenance and upon putting it back together the trigger won't completely cycle. It only goes about 7/8 back. I can fire it by manually pulling the hammer back and then use the trigger to release it, kind of like a springer. I belive the problem has to do with the slide as the trigger was left untouched. Any help would be very much appreciated.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.