TM VSR 10 Disassembly/Assembly Guide

17231 Views 20 Replies 9 Participants Last post by Dead Ace Shot, Mar 5, 2013

fuzzywolly

Discussion Starter · Jul 7, 2012

Here is part one to disassembling your VSR 10, see part two for hop up (see below).

I know Jack Buendgen wanted a vid up on how to take down the hop up unit, and made a vid on how to take down your VSR 10 and get to all the bits and pieces including the shim mods that I added for increased performance. Hope you like the vids.

Part three for assembly will be added soon.

Save

Reactions: 1

1 - 1 of 21 Posts

SixCell

· #16 · Jul 14, 2012

AtR said:
IMO, the detailed - the better. People can always skip the unwanted parts themselves.

Got a game in 5hours =)

In your video you're using white lithium grease, would http://www.gt85.co.uk/ work as a substitute? I've been recommended to use that over grease on a VSR, exact words being "Don't grease anything on a VSR, use a few drops of gun oil or a squirt of silicone".

I must say, the only place i use grease i in the gears in a AEG.

In my sidearms & gbb rifles & Snipers i ONLY use PTFE teflon spray.
Only the best in my guns

(No silicone, when it dries out it gets sticky)
Kinda suprises me that so few of you others use it...

Save

1 - 1 of 21 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month