Airsoft Sniper Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #1 ·
Just installed a G&G cocking piece, and now my trigger sear rides much too low to be pressed on by the part above it (Bolt sear?). I played with the adjustment screws for nearly two hours, but still wont work unless I move it with a tiny screwdriver. I think I have the same problem Ripperkon did.
 

·
Registered
Joined
·
1,033 Posts
Discussion Starter · #3 · (Edited)
SO I just need a small shim? I'll cut up a washer or something and epxoy it in place.

How hard is the trigger mech to take apart/put back together?

EDIT: Just watched a video, looks likes less of a pain that i thought. I'll do it tonight.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top