Airsoft Sniper Forum banner
1 - 13 of 13 Posts

· Registered
34 Posts
Discussion Starter · #1 ·
Hey, recently I received a PDI hopup chamber, and 6.01 inner barrel, and a new bucking. After putting it all together i found that the diameter of the outer barrel was smaller than the diameter of the hopup chamber, is there any solution to this? Would i have to get a new outer barrel? Thanks in advance
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.