Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,011 Posts
You're pretty much screwed, all you can really do is just enjoy the rifle for however long you can. Clone 96's are made pretty horribly in that aspect. If you do decide to upgrade the spring back to what it can push straight out of the box, you'll find that you'll need to end up buying a new trigger assembly to hold that spring, and you'll probably need a reinforced bolt, because chances are that you're going to be so used to recycling the bolt how you can when they're stock, you'll get used to it when it's a stronger spring, and break it off (Seen this happen a dozen times).

My best advice I can give you is save up another $200, and buy a new trigger assembly (PDI or something of a higher quality) and then go pick up a PDI 300% spring. You should be good to go for a while, and if you're careful, you won't need to spend another $50 or so on the bolt. Or you could always try and sell that rifle to someone less experienced in the game, and pick up a Maruzen, and then just upgrade only the spring. Both avenues you take will end up costing you about the same, but in my opinion Maruzen has a much better feel to the stock and just overall appearence.

-Mosin
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top