Airsoft Sniper Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
824 Posts
Discussion Starter · #1 ·
Well everyone said this to me so make a intro post. This is how go to the beginner section and as a subtopic you should see introduction. That is the wrong kit and with all kits like that they are usually crap. Here is a link to the gun that the upgrade kit fits in. http://images.hobbytron.com/LP-SOFT-M324SR-A-lg.jpg . The upgrade kits if your looking for cheapy but maybe sucky go with the Evike rebrand. I think they are decent not the best.
Here The kit. Saying this is around the fps of the standard L96. So if you don't want new sear. You dont have too I just recommend it.
http://www.airsoftpost.com/product_info.php?cPath=648_656&products_id=35641
I don`t know if this kit your have to use your piston cup but someone will come help me soon.
 

·
Registered
Joined
·
2,199 Posts
The intro thread is in the beginners section. THekit you bought is fine for a person on a low budget, just don't use the spring that comes with it unless you want to break your trigger. There are plenty of home mods you can do, such as lube up parts, teflon parts and for consistency put little bit of foam into the gaps of the hop up chamber.
 

·
Registered
Joined
·
74 Posts
Yeah, I saw numerous warnings on other posts about the danger this spring poses to my trigger. So I bought an upgraded UTG metal trigger, which is currently backordered somewhere in Japan
 

·
Registered
Joined
·
74 Posts
Currently (dont ask why) I have the new spring in there, but with the old barrel and hop up. Will the new shorter barrel and hop up mirraculously fix the accuracy problems i am still having at 200 and even 150 feet?

Dont jack my post bro!
 

·
Registered
Joined
·
74 Posts
Thank you very much. Do you think the spring suggested by nelson would be a suitable upgrade? Furthermore, how do I clean my hop-up/ lube the internal parts, and how would that make a significant difference? I hope I dont seem dim, I just want to understand WHY I should do things, not just that I should do them..
 

·
Premium Member
Joined
·
3,494 Posts
The barrel could be all greasy as most stock rifles come that way. Overgreased and greased where grease should not be located.

I typically use a paper towel on the end of the unjamming/cleaning rod, and put a little windex down the barrel. Then I make sure to clean it all out and my barrel is nice and shiny and clean.

For the bucking, here ya go: http://www.airsoftsniperforum.com/phpBB/phpBB3/viewtopic.php?t=2115
 

·
Registered
Joined
·
824 Posts
Discussion Starter · #10 ·
I have heard dont attack me or anything but on the KWA forum I heard using silicon oil and a paper towel actually bad and you and you should try water and like a strip of a t shirt, but I think the bucking cleaning guide is good. I think my kit would be easy and simple because It has all your need and the L96 should be able to handle m150 springs because it shoots around the m150 spring range and a metal piston and spring guide is always a bonus.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top