Airsoft Sniper Forum banner

UTG L96 upgrade help

1912 Views 10 Replies 5 Participants Last post by  fuzzywolly
Well everyone said this to me so make a intro post. This is how go to the beginner section and as a subtopic you should see introduction. That is the wrong kit and with all kits like that they are usually crap. Here is a link to the gun that the upgrade kit fits in. . The upgrade kits if your looking for cheapy but maybe sucky go with the Evike rebrand. I think they are decent not the best.
Here The kit. Saying this is around the fps of the standard L96. So if you don't want new sear. You dont have too I just recommend it.
I don`t know if this kit your have to use your piston cup but someone will come help me soon.
1 - 3 of 11 Posts
Clean bucking and hop up and perhaps that will help with your stock hop up.
The barrel could be all greasy as most stock rifles come that way. Overgreased and greased where grease should not be located.

I typically use a paper towel on the end of the unjamming/cleaning rod, and put a little windex down the barrel. Then I make sure to clean it all out and my barrel is nice and shiny and clean.

For the bucking, here ya go:
I don't use silicon on my barrel...
1 - 3 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.