Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
346 Posts
Discussion Starter · #1 ·
This post was annoying me because it was so long and outdated. I got a Maruzen and used the UTG for scrap parts. Project is done.

It was my first time using a clone as a basis for a project (or for anything other than the stock), so I was trying to get some intel. Anyway, just get bar-10's, everyone
 

·
Registered
Joined
·
9 Posts
I was thinking the exact same thing as you. I'm looking on trinityairsoft.com for upgrades and i emailed their tech support and they said since the UTG is a clone, it should work with the maruzen upgrades, but they're not sure. Wow, that was one huge run on sentence. Yeah, I'm thinking of upgrading the spring to a 210 spring, new piston, ball bearing spring guide, and I would need a stainless steel sear. Just think, shooting aluminum .3 gram bb's with that sucker. If you do find good upgrades, message me.
 

·
Registered
Joined
·
4 Posts
Hey, I might have my hop-up perfectly, or just amazing luck. But I can constantly get 200 ft head-shots with my stock UTG L96. All I have to do is aim about 1/2 inch about someone's head and..boom. head-shot. And I actually have measured it out. I have a 200 ft long measuring tape from a track & field event
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top