Airsoft Sniper Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
562 Posts
Discussion Starter · #1 ·
I need help...

Would anyone have a source for the little nylon ring bushings that fit inside of the VSR-10 receiver? These are the rings that the cylinder are guided on.

The two I have in my M28 are rather out of spec, and cause my cylinder to touch the receiver when pulled, thus scratching the cylinder rather severely.

if there is no real source; has anyone repalced their receiver with aftermarket units, and be willing to sell me their old parts?
 

·
Registered
Joined
·
562 Posts
Discussion Starter · #3 ·
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top