Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter · #1 ·
Hey, I need to run this over and get a few answers on these parts.
These are the Parts I will be getting:
1. PDI ezy hard piston.
2. PDI v-trigger.
3. PDI version 2 variable hop up chamber.
4. PDI tapered cylinder head.
5. PDI VSR-10 spring guide.
6. PDI 140 spring.
7. EDGI 6.01mm tightbore
What I needed cleared up is, will the tapered cylinder head fit the stock TM VSR and JG bar-10 cylinder? It will be a temporary bolt till I make my next order for the Bull barrel.
Also do I need any other sort of parts for the hop up chamber, like a bucking or nub.
Thanks in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top