Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,384 Posts
So the wraith will fit into a JG stock, but NOT a Tokyo Marui. I had a Marui stock I dremmeled up and made a custom mount with a scope ring. But to be honest, even with the wraith mounted in the stock, the leverage isn't as nice since you have to use your finger tips. I found myself not being able to fully puncture the cartridge and it's blowing all the co2 out haha. Also, over time the puncture point may need adjusted so you'll have to take it all back apart again. Oh my wraith setup I just have an offset 25mm mount on the side of my scope and it's perfect.

The rest of your upgrade list looks good, if you want to save every little bit of co2 you can run a longer barrel. Running a Wolverine cylinder allows you to run the air line externally, making it easier to swap between the wraith and an hpa tank. I have a video of the options;

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top