Airsoft Sniper Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter · #1 ·
So in about 6 months time my son will finally have all the parts necessary in order for me to begin the process of upgrading the VSR10 into an HPA dream machine. I am going to try to get a little ahead of it now so I can make sure all of his progress is not wasted as he has limited resources.

Here is the rundown of the parts list for it:
-Wolverine BOLT engine
-Wraith CO2 system
-Maple Leaf Bucking
-Action Army hop up chamber
-Prometheus 6.03 inner barrel

Now a few questions I have for you guys.

I am seeing a lot of people saying that the Wraith system does not actually fit within the stock without lots of alterations so we are looking to affix it to the outside of the gun, has anyone else here done this as well? If so what did you do to get it to stay?

I also noticed quiet a few people mentioning that the BOLT is not a perfect fit within the system and that the lines get pinched frequently. I am trying to 3D print a design to clip into place in order to keep the line from being pinched but I do not know the measurements to work with, does anyone have the diameter measurements of the line so I can start getting some concepts drawn up.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top