Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi All,

Firstly, hello........new member here. Been airsofting over 10 years but only just recently made the transition over to sniper.

My question is, is the stock TM cylinder capable of functioning correctly with an upgraded m150 spring, upgraded 90 degree piston and spring guide?

I already have a 90 degree trigger set, I'm just curious if the cylinder can take it? That's after I remove that pesky pin holding the cylinder head in place of course!

All the best.

Dan.
 

·
Registered
Joined
·
59 Posts
Depends what brand spring it is. If it's airsoftpro then it breaks, because an airsoftpro m150 shoots like 170-180 m/s. If it's action army or laylax then it should be okay.
 
  • Like
Reactions: 1tonne

·
Registered
Joined
·
4,148 Posts
An original TM one? I've had the cylinder head fly out with as little as 400 fps. The original TM cylinders are pretty weak.

You can try it, but not a huge surprise if it doesn't hold up. Don't fire the gun without the hopup chamber in place if you do try it.
 
1 - 4 of 4 Posts
Top