Airsoft Sniper Forum banner

What RS Model 700 stocks will fit a Tanaka?

2042 Views 7 Replies 4 Participants Last post by  Penny Cooper
I know some fit, I'm just not sure what. I wan't to get a cheap synthetic stock to replace my AICS for this winter. I've got the trigger guard and mag release from a KJW, which i'll need.

Any one have any idea which ones will fit with minor modification? I don't mind Dremaling a little.
1 - 8 of 8 Posts
All the short action RS stocks will but with some filling ans sanding at some points.


Wolf
All the short action RS stocks will but with some filling ans sanding at some points.

Wolf
Ah, thank you! Does it matter if its ADL or BDL? I'm pretty sure only a BDL would work.
Both are the same the difference is that:
BDL just has the bottom metal/hinged floorplate.
ADL has blind magazine, no bottom metal.

I'd say go with ADL since you have the KJW floor plate

Wolf
Both are the same the difference is that:
BDL just has the bottom metal/hinged floorplate.
ADL has blind magazine, no bottom metal.

I'd say go with ADL since you have the KJW floor plate

Wolf
Hmm.. Might just pick up a stock for my Real R700 and use the one thats on there now for my Tanaka.
I had a SA BDL and I had to dremel out the magazine well. A bit of cutting/filing in areas and it fit pretty well and looked good.
I had a SA BDL and I had to dremel out the magazine well. A bit of cutting/filing in areas and it fit pretty well and looked good.
What did you end up paying for it?
R700 stocks works good for u, and u can try it out once.
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top