Airsoft Sniper Forum banner
1 - 1 of 14 Posts

· Registered
207 Posts
Get those custom sears cut without the bearings and then try and get some abec 7-8 bearings for those sears. abec 9 is too delicate for a gun. Also dry pull the trigger about 200 times to get all the parts in sync cause my best pal had a draw weight that was enormous just because there was a half a mm snag in the sears.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.