Airsoft Sniper Forum banner
1 - 16 of 16 Posts

·
Registered
Joined
·
228 Posts
Discussion Starter · #1 ·
I've got a stock (DIY modded) BAR10 with no upgrade parts. Will the IR Hop Z kit (http://www.airsoftgi.com/product_info.php?products_id=10710) fit the barrel window of my BAR10? The kit comes with 3 different patches, and I'm just wondering it one was designed for BAR10/VSR10 barrels. Also, can anyone tell me if IR hops have good airseals? Would I be better off with a KA or Nineball standard bucking? What about the REAPS bucking? Also, will the IR hop work with the TDC mod? Thanks!
 

·
Registered
Joined
·
212 Posts
Not entirely sure if one of the patches will fit as a drop in from the Z-kit. But if it doesn't you can sand it and cut it down to fit properly. As for airseal, the nice thing about using an R-hop/IR-hop is that you can have the advantages of a hard bucking (able to use heavier bb's because of higher fps) with the advantage of a soft bucking (better airseal). This is achieved because the patch itself acts as the hard bucking while the bucking that goes over the patch can be soft therefore giving you the airseal.
 

·
Registered
Joined
·
212 Posts
Here's an issue I have with my Z-kit. You get three patches ones large another is medium and the last is small. Let's say your gun needs a large patch. So you cut the patch, but you unfortunately mess it up. Now you have two other patches that are to short for your hopup window.

Luckily for me I kinda messed up my medium patch, so just used my large one and sanded it down and cut it properly. Now it works fine. But the next time I buy more R-hop patches I'm going to get the regular kit. That way I have three oversized patches and can actually use all three.
 

·
Registered
Joined
·
36 Posts
The rhop is adjustable, but I believe you'll need a flat hop arm; and it will work with the tdc mod since the tdc is just a more stable way of putting pressure on the arm, which then puts pressure on the hop bucking/rhop. I myself will be doing an r hop install soon in my vsr
 

·
Registered
Joined
·
14 Posts
The rhop is adjustable, but I believe you'll need a flat hop arm; and it will work with the tdc mod since the tdc is just a more stable way of putting pressure on the arm, which then puts pressure on the hop bucking/rhop. I myself will be doing an r hop install soon in my vsr
so you don't need any nub, just the type B arm should be enough ?
Or would that create to much hop ?
 

·
Registered
Joined
·
774 Posts
"Please check the dates...

Wolf"

-Quote wolf

You would still need a bucking. Please consider creating an introduction post for our knowledge on you and your experience. A simple question there won't hurt. Thank you

Razinger | The one, The only..
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top