[Inoa]

Hello,
i installed the Wolverine Bolt in the SSG 10 A3 and the Air seal between hopup rubber and cylinder head is leaking, not sure if it needs to be pressed more onto the hopup rubber. It definitely goes all the way. I have a goog air seal with the standard spring setting. For me, that means holding the inner barrel and pressing the trigger after 2 seconds, letting go and air should still be able to come out. With the wolverine its complete gone. Im getting 1.8J with 120 PSI shooting 0.45g BBs. Its a Standart Wolverine Bolt without the tuning kit for high pressure. The Regulator is a redline mini Sfr. Would the kit and a high pressure Regulator fix it ?

 

[SiliconeSword]

Well the BOLT does not hold air if you put your finger over the end of your cylinder or barrel, so unless you do the tissue thing where you put a tissue over your empty mag well and fire, I'd not worry too much.
If you do get a bit of tissue movement I suggest that you try screwing your outer barrel back another turn (you may need to sand away a bit of material from it), or add a piece of card stock under the metal clip on your bucking. Also try pressing the and cap on your cylinder with your thumb as you fire, and make sure that you are actually hitting the face of your hop chamber.

 

[Inoa]

Thank you for your quick response. I'll try again on Sunday when I'm back from the game. The tutorials say that the vsr/ssg10 receiver needs the screw to be right in the middle, that's not the reason, is it? And the ssg10 had general air issues, so there was the gen2 cylinder head too.

 

[SiliconeSword]

You don't need whatever anti rotation screw it comes with, but what I mean by screwing it in further is doing another complete turn. You may not have space for it, so you'd probably have to file down the end of the outer barrel a tiny bit. I'd save that until you run out of options though, as it's not reversible and you want a solid lock up between your receiver and barrel.

 

[Inoa]

Should i try to fix it after i got a New Hopup Camper and the SS Nub+S-Hop ? The Cylinder Head is perfect sitting. The First two are with the Front Receiver.

 

[SiliconeSword]

That looks good, so unless it doesn't pass the tissue test I'd leave it

 

[.Jason ke]

Yeah


Sent from my iPhone using Tapatalk