Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
Basically, I'm looking for any and all upgraded internals for the APS2. I don't need a hop chamber, but could use an aeg barrel (590mm preferred, high quality a must), and all parts of the cylinder.

I am also looking for any working APS2 magazines.

I'm not a novice, so please, don't try to pawn off your low quality stuff here, Laylax and PDI are preferred.
 

·
Registered
Joined
·
58 Posts
Discussion Starter · #3 ·
Is that the same thing as the 3 Element piston? That's the one I'm really looking for.

Spring is good if it's around 450 fps and very consistent, I want to keep this to a lower fps for longevity. Spring guide would be great.

And if you have a higher end TBB I'd be interested in it, I have the Aero chamber, since I couldn't find any PDI hops.
 

·
Registered
Joined
·
58 Posts
Discussion Starter · #5 ·
Depending on the price I'll give the neo a whirl.

As for the tbb, the longer the better. Its going into an M99 and I can cut/crown it if it is too long. I'm only looking for something high end for the barrel though, don't want to cut any corners on accuracy.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top