WTS: Cusom Built Snow Wolf M99 (Woogies)

I'm looking to sell my custom built snow wolf m99. It was built for me by a custom builder named woogie over on the airsoft sniper forum. Here is the process of it being built.

http://www.airsoftsniperforum.com/phpBB/phpBB3/viewtopic.php?t=1691

The rifle started out as a bone stock Snow Wolf M99.
The rifle was then customized a little bit. But everything that has been done can be replaced.



So here is what I have done to the rifle as of right now......

The rifle started out as a bone stock Snow Wolf M99.
The rifle was then customized a little bit. But everything that has been done can be replaced.
I have put a set of Gaurner APS-2 stainless steel sears.
I have also used the barrel from a MK96 and shortened the overall length of the barrel.
I have also made a custom MOCK MOCK suppressor for the end of the barrel.
The MOCK suppressor is bolted to the outer barrel by 3 hex bolts.
The bolts go through the suppressor and then through the outer barrel.
There is no contact between the bolts and the inner barrel.
This makes the outer barrel apart of the entire rifle and there is no wobble what so ever.
I have removed the spot where the original bi-pod attached, and have mounted a single bi-pod stud.
I also have an Aero Chamber for the rifle as well and one mag

The only problem is that the gun needs a new piston and here is the link to the piston set for ONLY $30 dollars.

http://www.airsoftpost.com/product_info.php?products_id=32803

If you purchase this gun I will subtract $30 dollars from the final price you pay for it, to make it even.

Please pm me about info about the gun. I'm accepting all reasonable offers.

Thanks gorem.

P.S. scope is not included