Airsoft Sniper Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter · #1 ·
First of all, I want to thank you all for what you guys do, both users and mods! =D

This time, I need some of your advice...
Because I don't have anything close to your level of experience in internal parts and that stuff, I'm asking you guys:

I really want my m16 to have a little bit more precision. Therefore I want to get myself a precision barrel, but I need some help choosing which type... At "www.evike.com" there is some barrels with teflon coating. Wouldn't they be a good solution? Since teflon i svery slippery and stuff?
I'm not going to spend an awful lot of money on the barrel though.
Also. Would it be wise to get a new hop-up rubber or something too?

The gun is shooting somewhere between 400 and 450 fps, and the barrel length is 510mm , if that has some kind of impact on which barrel i should choose...

Sorry if it is too many grammarmistakes or anything. I'm in a hurry right now XD

Happy snipin'!

-2Echo
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #6 ·
Bad experience with both? How?

I don't want to buy crap =(

edit:

I also found out: My stock barrel is 480 mm??? is this normal?
But i have another 10 mm left before the flash hider/silencer.

Just wondering about the 480mm stock barrel ???
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #10 ·
I think that a 509 will fit. I really don't care too much about the barrel sticking out into the flash hider a couple of mm... but do you really think i shall buy the madbull barrel?
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #12 ·
Well... then I'll save up some more money and buy the barrel later some time.

I have to buy myself some stuff for a new 48 hour OP, Operation takedown-.- My team, TRF is being PMC's, going for some drugdealers and protecting some VIP fellah' :) Most of the mission is secretly planned by the leaders so I dont know much about it.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top