Airsoft Sniper Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #1 ·
Hello!
I have had an EO-tech clone for a while now but never really got around to using it. I tried sighting it in recently but encountered a problem. The elevation adjustment screw gets stuck at a certain point when I try to lower the reticle where I need it to go. Are they easy to take apart to repair?
Anyone have any tips for accurately sighting it in once and if I get it to work again?
Thanks!

- Topa
 

·
Registered
Joined
·
133 Posts
Discussion Starter · #3 ·
With replicas you have to make sure your hop is adjusted correctly and you have a solid cheek weld, otherwise the paralex the sight gives will mess you up.
Well my hop is fully adjusted and by cheek weld is very solid. I even flipped up my iron sights and tried to align the holo to the sight but it would not go low enough which is what I need.

- Topa
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top