Airsoft Sniper Forum banner

Zeroing Scope

1709 Views 5 Replies 5 Participants Last post by  Unforgiving Apple
Hey guys!

I've been trying to zero the NCStar 3-9x40 scope on my ASR recently. I've had a heck of a time. Even with the hop up (PDI 96) turned off, the groupings are still a good 12" from my POA at 50', even further at 100' and so on.. My scope is adjusted as far as it will go towards the groupings. Should I get a different scope?

I'm using .36's, and like how they are working. I'm geting groups that I am perfectly happy with (5 shots in a 5 inch circle), I just can't get my crosshairs on those groups.

Any advise?
1 - 2 of 6 Posts
The scope is only several months old, and the rings look good. It was one of the scopes that you have to unscrew a cap to reach the windage and elevation knobs.
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.