Airsoft Sniper Forum banner
1 - 7 of 7 Posts

Vision

· Registered
Joined
·
177 Posts
Discussion starter · #1 · (Edited)
So I recently decided to squeeze every drop of performance out of this gun. Short of getting Reliku's receiver, I'm right there, including installing a Wolverine bolt, Storm Regulator, and Wraith kit. As it stands I have a couple questions I was hoping some people could help answer.

My field limits hpa sniper rifles to 2.3J (chrono'ed with .32) Using a 428mm CJ barrel what weight bb would give me the best performance?

Does anyone have any experience with what psi I will most likely need to run to achieve these joules, without having to spend the money to buy .32 bbs and a chrono, just to figure out if I need to get the tuning kit? I'm pretty sure I have perfect compression, so there shouldn't be any variation in the volume of air.

Lastly, how many shots can I expect out of a single cart at different psi settings you have experienced with or without the air saver tuning kit?

Thanks for the help.
 
2.3J is enough for a 0.43 I hesitate to go with a 0.45 since that's a bit on the slower side for bb travel time. (roughly 320 fps for 2.3J with 0.45g) If a bit slower travel time doesnt bother you, then go with the heaviest weight you can hop.
 
What you asked is highly dependant on your setup.

Get the parts, mount them, measure the gun. if you need more than 140PSi get the tuning kit.

Shot count on cartridge also depends on the PSI you are running so there is no answer here.
 
hello airsoft snipers! im new to this site :)

and wondering i got a bolt + Wraith co2 in my vsr, and like to know if a can adjust my psi to reach for 140-150ms for my maple leaf 75% with 0.45bbs

Ps sorry for bad spelling
 
New wolverine bolt and wraith stock not shooting above 2.1 jules at 170 psi

Hello guys, i just got a new wolverine airsoft sniper bolt and c02 wraith stock back from the local airsoft shop but on the chrono i cant get above 2.1 jules. is there anything i can do to help fix this? On a side note, is it safe for my bolt to run it with this high psi?Thanks again im new to airsoft and i really appreciate it!
 
1 - 7 of 7 Posts